Doubling the voltage in a circuit doubles the current if what is held constant?

Answers

Answer 1

Answer: The Resistance needs to be the same to allow the current to double with the voltage.

Related Questions

When a 191 N bag of nails hangs motionlessfrom a single vertical strand of rope, howmuch tension is exerted in the strand?Answer in units of N.
________ is the name for when a director decides where and when performers move and position themselves on the stage.
What experimental evidence was provided for the nuclear model of the atom?
stone thrown vertically upward with speed of 15.5m/s from edge of cliff 75.0m high. how much later does it reach bottom of cliff?
Two people pull as hard as they can on horizontal ropes attached to a boat that has a mass of 200 kg. If they pull in the same direction, the boat has an acceleration of 1.42 m/s2 to the right. If they pull in opposite directions, the boat has an acceleration of 0.509 m/s2 to the left. What is the magnitude of the force each person exerts on the boat

A box weighing 18 N requires a force of 6.0 N to drag it at a constant rate. What is the coefficient of sliding friction?

Answers

Use f = uN to find the coefficient of friction. We know friction (6.0 N) and the normal forces (18 N), so plug them in to the equation which gives us 6 = u18. Solving for u: u = 0.33

The Correct Answer Is 0.33.

When describing a maritime polar air mass, you might say it formed over _____ and is _____.

Answers

The correct answer for the question that is being presented above is this one: "an air mass that formed over land. it is cold and dry." When describing a maritime polar air mass, you might say it formed over land and is cold and dry. It's temperature can range from around freezing to near 20 degrees Celsius

Answer:

water, cold and moist

Explanation:

I just did a test on it and got it wrong using land, cold and dry and got it right using this anwer

Jumpering out the resistors in a resistance-controlled three-speed fan will cause the motor toa. run at highest speed.
c. run at lowest speed.
b. run at medium speed.
d. stop immediately

Answers

The answer to the question stated above is letter a. run at highest speed.

Jumpering out the resistors in a resistance-controlled three-speed fan will cause the motor to run at highest speed. If resistors are jumpered, the three-speed fan will over speed and probably burns out.

About half of the electricity in the United States comes from burning _____. coal oil natural gas methane

Answers

i'm pretty sure the answer is burning coal

I say oil...................

Solids are usually more dense than: gases liquids plasmas all of the above

Answers

Yes, this is because particles in a solid there are more particles which are touching. They can only vibrate. But particles in a gas are far apart. This is the same for liquids to.

Determine the volume at the equivalence point if a 0.100 M NaOH(aq) solution is used to titrate the following acidic solutions: (a) 50.0 mL of 0.200 M HBr(aq) (b) 30.0 mL of 0.150 M HNO3(aq)