How does ice float on water?

Answers

Answer 1
Answer: a substance floats of it is less dense, or has less mass per liquid volume than other components than the mixture.

Related Questions

Karissa is conducting an experiment on the amount of salt that dissolves in water at different temperatures. She repeats her tests several times using the same procedure.What can Karissa do to further increase confidence in the results of her experiment? have another scientist run the same exact procedure in her lab include several other liquids for comparison calculate the average amount of salt that dissolves to summarize findings make sure the experiment follows a specific procedure that allows other scientists to produce the same findings
"One step in the manufacture of silicon wafers used in the microelectronics industry is the melt crystallization of silicon into a crystalline silicon ingot. This processis carried out within a special furnace. When the newly solidified ingot is removed from the furnace, it is assumed to have a uniform initial temperature of 1600 K, which is below the crystallization temperature. At this temperature, the thermal conductivity of silicon is 22 W/(m•K), the density is 2300 kg/m3, and the heat capacity is 1000 J/(kg•K). The hot solid silicon ingot is allowed to cool in air maintained at a constant ambient temperature of 30°C. The diameter of the silicon rod is 15 cm. End effects are considered negligible. The convective heat transfer coefficient is 147 W/(m2•K). What temperature will exist 1.5 cm from the surface of the ingot after a cooling time of 583 sec (9.72 min)?" Consider the rod as acylinder placed vertically.
What happens when a blaring siren moves away from you
In the cells of the human body oxygen molecules are used directly in a process that?
A small piece of Styrofoam packing material is dropped from a height of 1.90 m above the ground. Until it reaches terminal speed, the magnitude of its acceleration is given by a = g − Bv. After falling 0.400 m, the Styrofoam effectively reaches terminal speed, and then takes 5.40 s more to reach the ground.(a) What is the value of the constant B?s-1(b) What is the acceleration at t = 0?m/s2 (down)(c) What is the acceleration when the speed is 0.150 m/s?m/s2 (down)

The main reason ice blocks became unpopular for cooling food was

Answers

The source of the ice was unsanitary

Answer:

The source of ice was unsanitary :>

Explanation:

Which of the following states of matter is always a good conductor of electricity? solid, liquid, gas, or plasma **:/ Thank you!

Answers

Plasma...I believe is always a good conductor of electricity. I was tempted to say a solid, but not all solids are the same in composition and that goes for liquid and gas as well.

Hopefully this helped and good luck.

An apple falls to the ground due to: (A) frictional force. (B) muscular force. (C) gravitational force. (D) electrostatic force.

Answers

The answer is (c) an apple falls to the ground due to gravitational force

Viscous lidocaine 2% 30 mL Maalox (do not substitute Kaopectate) 60mL Diphenhydramine (use on hand stock 12.5mg/5mL elixir) 75 mg Carafate 1gm/10mL 40 mL The doctor wants the patient to use a daily dose of 2 teaspoons. How many doses are in the final product?

Answers

Answer:

There are approximately 16 dozes in the final product

Explanation:

The given parameters are;

The viscous lidocaine 2% 30 mL + Maalox 60mL + Diphenhydramine (12.5 mg/5mL elixir)75 mg + Carafate 1gm/10mL 40mL

The total volume becomes;

30 mL + 60 mL + 5 × 75/12.5 mL + 40 mL = 160 mL

1 Teaspoon = 4.928922 mL

Therefore, 2 teaspoon = 2 × 4.928922 mL = 9.857843 mL

Which gives;

The number of doses in 160 mL = 160 mL/(9.857843 mL) = 16.2307312 doses

Which is approximately 16 doses

Therefore, there are approximately 16 dozes in the final product.

The final product contains viscous lidocaine, Maalox, diphenhydramine, and Carafate. There are approximately 10.5 doses in the final product.

The final product is a mixture of viscous lidocaine, Maalox, diphenhydramine, and Carafate. The doctor wants the patient to use a daily dose of 2 teaspoons.

To calculate the number of doses in the final product, we need to determine the total volume of the mixture and divide it by the volume of a single dose.

First, add the volumes of the individual components: 30 mL + 60 mL + 75 mg + 40 mL = 105 mL

Since the doctor wants the patient to use 2 teaspoons (10 mL) per dose, divide the total volume of the mixture (105 mL) by the volume of a single dose (10 mL): 105 mL ÷ 10 mL = 10.5 doses

Therefore, there are approximately 10.5 doses in the final product.

For more such questions on doses, click on:

brainly.com/question/34277095

#SPJ3

You have a very old service manifold and the high-pressure gauge on this service manifold set has a continuous scale, calibrated to read from 0 to 500 psig. TRUE or FALSE.

Answers

That statement is FALSE

the scale that calibrated to read from 0 to 500 is usually the standard used by the new kind of service

the older one usually only take up to 340

hope this helps

How does the law of conservation of energy apply to machines?Machines create energy from scratch.

Machines consume energy until no energy remains.

Energy transferred to a machine equals energy transferred from it.

Engineers break the law of conservation of energy by using ma

Answers

Energy transferred to a machine equals energy transferred from it. It is because according to conservation of energy we can't create or destroy energy so, energy remains constant however, their form can be change by machine's

In short, Your Answer would be Option C

Hope this helps!

Answer:

Energy transferred to a machine equals energy transferred from it. It is because according to conservation of energy we can't create or destroy energy so, energy remains constant however, their form can be change by machine's

Hope this helps!

Explanation:

In short, Your Answer would be Option C