What is a limitation of the electron cloud model theory that a law about electrons would not have?

Answers

Answer 1

Answer:

Explanation:

Electron cloud model describes the region in an atom which negatively charged and which has probability to find an electron. according to this model, an electron can move closer or away from the nucleus that is it can be inside the nucleus but according to Bohr's model, an electron is always at a fixed distance from the nucleus. Thus, it is the limitation of the electron cloud model but still it is a widely accepted model.

Answer 2

Answer: Electrons couldn't orbit the nucleus like miniature planets~!

Related Questions

Which of the following shows the abbreviation for a unit of density? (a) lb/mL (b) g/cm (c) g/cm3 (d) L/kg
How many atoms of oxygen in the chemical fomula 2ca(cio2)2?
Race car drivers must slow down as they make turns on the track. This is best explained by the law of inertia. Which statement best describes inertia for the car going around a turn? A) A body in motion stays in motion at the same speed. B) The speed of the car going into the turn must be conserved. C) The speed around a turn is proportional to the radius of curvature of the turn. D) A body in motion tends to continue in a straight line and requires a force to turn.
You observe a distant galaxy. you find that a spectral line normally found in the visible part of the spectrum is shifted toward the infrared. what do you conclude?
Which of the following areas would most likely have the deepest layer of topsoil?

Which concept represents most encompassing aspect of our lives

Answers

the most ecompassing aspect of our lifes is emotional health

physics Test 2 In a double slit experiment, if the separation between the two slits is 0.050 mm and the distance from the slits to a screen is 2.5 m, find the spacing between the first-order and second-order bright fringes when coherent light of wavelength 600 nm illuminates the slits.

Answers

Answer:0.015 m

Explanation:

Given

distance between two slits(d)=0.050 mm

Distance between slit and screen=2.5 m

Wavelength $(\lambda )=600 nm$

and distance between First order and second order $=(D\lambda )/(2d)$

$=(2.5* 600* 10^(-9))/(2* 5* 10^(-5))$

$=15* 10^(-3)$

=0.015 m

a car is moving with a constant speed of 20 meters per second.What total distance does the car travel in 2 minutes

Answers

There are 120 seconds in two minutes, so to find the answer, you multiply 20 x 120 to get 2400 meters.

Final answer:

The car travels a total distance of 2400 meters in 2 minutes at a constant speed of 20 meters per second.

Explanation:

Distance is the measurement of space between two points, typically in terms of length or spatial separation. It is a fundamental concept used in various fields, including physics, geography, and mathematics.

To find the total distance travelled by the car in 2 minutes, you need to calculate the distance covered in 1 second and then multiply it by the number of seconds in 2 minutes.

Since the car is moving at a constant speed of 20 meters per second, the distance covered in 1 second is 20 meters.

To find the total distance, multiply 20 meters by 60 seconds (1 minute) and then again by 2 (number of minutes).

The total distance travelled by the car in 2 minutes is 2400 meters.

Learn more about distance travelled here:

brainly.com/question/34023763

#SPJ2

What change takes place in a wave when the frequency of the wave increases? A.fewer wavelengths pass a given point per second

B.no change occurs in the number of wavelengths that pass a given point per second

C.a greater number of wavelengths pass a given point per second

D.the number of wavelengths that pass a given point per second doubles

Answers

The answer is C. As the frequency of the waves increases, a greater number of wavelengths pass a given point per second. From the wave formula, we see that there is an indirect relationship between frequency and the wavelength. thus, as the frequency increases the wavelength decreases resulting to a smaller distance between the waves which will show greater number of wavelengths between waves.

When a river or stream flows downward into a basin that is surrounded by high ground on all sides, what can form?

Answers

When a river or stream flows downward into a basin that is surrounded by high ground on all sides, a waterfall can form. The answer to the question above is 'waterfall' or 'waterfalls'. I hope this helps you on your assignments. You're welcome!

What factors affect the strength of the electric force between two objects

Answers

There are three factors:

The charge of the two objects. The electric force is proporcional to the product of the charges of both objects.

The distance that separetes them. The electric force is proportional to the inverse of the squared distance that separates the objects.

The media. The electric force constant of proportionality depends on the media: air, water, oil, glass.

Answer:c or 3 or the distance between the objects and the amount of charge on the objects

Explanation:

Bc i know it pls give me brainliest

Other Questions

What is produced when calcium reacts with fluorine in a synthesis reaction

Which explanation of the solar system best fits the observations of the planets and how they orbit the sun? (Points : 3) The gravity of a large, massive star passing the sun ripped off blobs of material from it that formed the planets.The planets formed at the center of a collapsing spinning cloud of gas and dust. The sun and planets formed from a collapsing spinning cloud of gas and dust. A comet hit the sun and sent off fragments that became the planets.

A child is sending pulses down a stretched rope at a rate of 2 pulses per second. The distance between the pulses is 5 meters. What is the speed of the wave?a. 5 m/s c. 2 Hz b. 10 m/s d. 2.5 m/s User: Longitudinal seismic waves are known as a. primary waves. b. secondary waves. c. surface waves. d. transverse waves.

Most of the Earth's volcanoes occurA. near the center of tectonic plates.B. where there are no tectonic plates.C. along tectonic plate boundaries.D. before tectonic plates can form.