Water is made of two hydrogen atoms and one oxygen atom bonded together. Julia is describing how water undergoes a physical change when it boils. She says that the particles shift to be farther apart and that the oxygen and hydrogen separate. She also says that the total mass of the steam is the same as the initial water, and that heat energy was required to cause the change. She finishes her description by saying that the steam can be turned back into water if it is cooled.what was her mistake?

Answers

Answer 1
Answer:

Answer:

atoms remain bonded to each other in physical changes.

Explanation:

Answer 2
Answer:

Answer:

c

Explanation:


Related Questions

Elle is playing with a ball in a bus that moves in a straight line with constant velocity. What can you say about the motion of the ball in the moving bus if Elle throws the ball vertically upwards?a the ball will fall back to her b the ball will land ahead of her c the ball will land behind her d the ball will move to the right
A hydrogen atom has one proton, two neutrons, and no electrons. Is this atom neutrally charged? Explainyour answer.
What kind of energy does a rubber band have when it is stretched? a. elastic potential energy b. gravitational potential energy c. kinetic energy d. chemical energy
The energy an object has because of its position is called _____
This image shows the direction of the flow of water through a constricted pipe. Which of the following happens as you move from position A to position B in the water pipe? A.The velocity of the water decreases.B.The pressure of the water decreases.C.The flow rate of the water decreases.D.The density of the water increases.

Resistivity measurements on the leaves of corn plants are a good way to assess stress and overall health. The leaf of a corn plant has a resistance of 2.3 MΩ measured between two electrodes placed 20 cm apart along the leaf. The leaf has a width of 2.3 cm and is 0.20 mm thick.Part AWhat is the resistivity of the leaf tissue?Express your answer to two significant figures and include the appropriate units.ρ=________Part BIs this greater than or less than the resistivity of muscle tissue in the human body?(A) greater or(B) less

Answers

Answer:

Part a)

\rho = 52.9 ohm- m

Part b)

the resistivity of corn plant is grater than the resistivity of muscle tissue in the human

Explanation:

Part a)

As we know the formula of resistance is given as

R = \rho (L)/(A)

here we know that

\rho = (RA)/(L)

here we have

R = 2.3 M ohm

L = 20 cm

Area = (0.023)(0.20 * 10^(-3))

Area = 4.6 * 10^(-6) m^2

now we have

\rho = ((2.3 * 10^6)(4.6 * 10^(-6)))/(0.20)

\rho = 52.9 ohm- m

Part b)

Resistivity of mucle tissue of human is is ranging from 15 ohm-m to 50 ohm m so here we can say that

the resistivity of corn plant is grater than the resistivity of muscle tissue in the human

The acceleration of an object increases by the force applied to it and decreases based on it's mass.

Answers

Explanation:

Force is defined as mass times acceleration.

Mathematically,          F = m × a

where             F = force

                       m = mass

                       a = acceleration

This shows that force is directly proportional to acceleration. So, when greater force is applied then acceleration will also increase.

Whereas acceleration is inversely proportional to mass. So, when there is increase in mass then there will be decrease in acceleration.

What does the atomic number of an element represent? Question 21 options: A. the number of protons in an atom B. the number of neutrons in an atom the mass of an atom C. the total number of protons, neutrons, and electrons in an atom D. the order in which the element was discovered

Answers

Answer:

A. the number of protons in an atom

Explanation:

The atomic number (also known as the proton number) is the number of protons found in the nucleus of an atom.

Answer:

A. the number of protons in an atom

Explanation:

How are the three cell layers of an embryo related to its development?

Answers

The said development of the cell where the three cell layers help out do it is called as Gastrulation. The three layers - called as ectoderm, endoderm, and mesoderm - tend to form as this happens. This is a process that's present in all living things except sponges.

Which lighting direction is used to create silhouettes?

Answers

Backlighting is used to create silhouettes 

HOPED I HELPED

Backlight is the answer


what’s 55mph to km/min? can someone explain to to me with the work so i can understand how to solve this

Answers

Hope this helps your answer pretty much :3