A guy named Kirby Had touched only a gear on the projector. Yet there was a out of the blue rip. Kirby did not mind at all and started the projector. Things went wrong and the tape would not work. What ripped?
Answers
The guy named Kirby didn't touch the power button on the projector. If he touched means the projector will work fine.
Explanation:
- Kirby touched the gear on the projector. He should check the projector carefully before operating the projector. But he didn't check properly.
- There was a blue rip in the projector. Kirby fails to notice the blue rip. Without minding that he has started the projector. So the tape and the projector is not working well.
- He should fix the blue rip and he should press the start button in the projector. The mistake is he didn't do that. This is the thing that made the projector ripped.
Related Questions
Compared to 15 mph on a dry road, about how much longer will it take foryou to stop at 30 mph on a snow-covered road?2 to 3 times4 to 6 times8 to 10 times
From the hazards blisted below, determine which could require foot protection
Which of the following is an example of a reliable source?A. A pamphlet on the economics of bridge building published by the organization Citizens Against Government Spending.B. An article in Environmental Science and Technology, a peer-reviewed journal published by the American Chemical Society.C. A newspaper editorial written by a United States senator.D. A blog post by a university engineering student.
Define the terms marker
Answers
Answers
Answer:
For me the answer was “the outcome of a series of scientific experiments”
Explanation:
2 Engineering use a (n) _______ process to solve problems
Answers
Answers
Carbon dioxide is a harmful substance may be stored there, If a building is too humid.
What is humid?
Humidity is a measurement of the amount of water vapour in the atmosphere. If there is a lot of water vapour in the air, the humidity will be high. As the humidity increases, it feels more humid outside. In weather reports, humidity is frequently described using the word "relative humidity."
It normally has a temperature of at least 90 °F and a relative humidity of at least 30% when the air is hot and humid.
Because excessive humidity slows down perspiration evaporation, humid heat is riskier than dry heat. Patients may endure organ failure, a rapid heartbeat, high blood pressure, and even death if they are not given the chance to cool off.
Thus, it is Carbon dioxide.
For more information about humid, click here:
#SPJ2
Answer:
carbondioxide
Explanation:
I= 0.000001m4
Determine:
1. The reactions and fixing moments
2. Slope and deflection at point (C)
Answers
Only option a and the option b follows the first law of thermodynamics.
Explanation:
As we know that the first law of thermodynamics tells the conservation of energy, that is why it is also called quantitative law.
From the first law of thermodynamics
a. Given that
W= 50 KJ,Q = 170KJ ,ΔE = 120 KJ
Yes, this follows the first law of thermodynamics.
b. Given that
W= 100 Btu,Q= -110 Btu ,ΔE= -210 Btu
This also satisfy the first law of thermodynamics.
c. Given that
W= 250 KJ,Q= -110 KJ ,ΔE=-100 KJ
Yes this does not follow the first law of thermodynamics.
d. Given that
Yes, this does not follow the first law of thermodynamics.
blue sternlight
yellow masthead light
white sternlight
Answers
The lights should be used is white sternlight.
What lights should be used in a sailboat at night?
A sailboat is operating under sail at night is known to be one where the operator of that sailboat is said to be operating under sails at darkness and so their sidelights should be (red - green) and stern light (white).
When they are said to be less than 20 meters in length, the three lights can be use altogether at or near the top of the mast.
Learn more about lights from
Answer:
White Stern light
Explanation:
According to boating regulations, navigation lights must be used for safety purposes when operating water vessels especially during the night.
The boating regulations for operating sailboats, specify that a white stern light must be used during hours from sunset to sun rise. This is to indicate the presence of the sea craft on the ocean, as well as its direction.
A stern light is a white light placed as closely as practical at the stern shining constantly. It covers an angle of 135 degrees, and helps show the direction of the boat.