Compute the electrical resistivity of a cylindrical silicon specimen 7.0 mm (0.28 in.) diameter and 57 mm (2.25 in.) in length in which a current of 0.25 A passes in an axial direction. A voltage of 24 V is measured across two probes that are separated by 45 mm (1.75 in.).

1. Sewage-treatment plant, a large concrete tank initially contains 440,000 liters liquid and 10,000 kg fine suspended solids. To flush this material out of the tank, water is pumped into the vessel at a rate of 40,000 liter/h. Liquid containing solids leaves at the same rate. Estimate the concentration of suspended solids in the tank at the end of 5 h.

Describe how a feeler gauge can be used to assist in the adjustment of a spark plug electrode gap​

An input voltage of 9.2 V is to be converted into its digital counterpart using an analog-to digital converter. The voltage range is 0 to 16 V. The ADC has 4-bit capacity. Determine: (a) What are the number of quantization levels, resolution, and the maximum quantization error of this ADC

The Rappahannock River near Warrenton, VA, has a flow rate of 3.00 m3/s. Tin Pot Run (a pristine stream) discharges into the Rappahannock at a flow rate of 0.05 m3/s. To study mixing of the stream and river, a conserva- tive tracer is to be added to Tin Pot Run. If the instruments that can mea- sure the tracer can detect a concentration of 1.0 mg/L, what minimum concentration must be achieved in Tin Pot Run so that 1.0 mg/L of tracer can be measured after the river and stream mix? Assume that the 1.0 mg/L of tracer is to be measured after complete mixing of the stream and Rappa- hannock has been achieved and that no tracer is in Tin Pot Run or the Rap- pahannock above the point where the two streams mix. What mass rate (kg/d) of tracer must be added to Tin Pot Run?

Use Newton's method to determine the angle θ, between 0 and π/2 accurate to six decimal places. for which sin(θ) = 0.1. Show your work until you start computing x1, etc. Then just write down what your calculator gives you.

In response to the market revolution:the legal system worked with local governments to find better ways to regulate entrepreneurs.Chief Justice John Marshall ruled that legislatures could not alter or rescind charters and contracts that previous legislatures had created.local judges protected businessmen from paying property damages associated with factory construction and from workers seeking to unionize.Massachusetts Chief Justice Lemuel Shaw held in Commonwealth v. Hunt that workers had no right to organize.corporations proved less able to raise capital than chartered companies did.