What is the speed of an ocean wave if it’s wavelength is 5.0 m and it’s frequency is 3/s?

Answers

Answer 1
Answer:

Answer:

15 m/s

Explanation:

We know that v = f * d where f = frequency & d = wavelength .

So here.

Wavelength = 5 m

Frequency = 3 s⁻¹

Hence Speed = 5 * 3 = 15 m/s


Related Questions

(a) A woman climbing the Washington Monument metabolizes 6.00×102kJ of food energy. If her efficiency is 18.0%, how much heat transfer occurs to the environment to keep her temperature constant? (b) Discuss the amount of heat transfer found in (a). Is it consistent with the fact that you quickly warm up when exercising?
What do you think most likely cause the differences seen in the two graphs for cold spring and normal wearher
URGENT!!!!!! Assume that a wire has 1.5 ohms of resistance. If the wire is connected to two batteries with a total voltage of 3.0 V, how much current will flow through the wire? 3.0 amps 2.3 amps 2.0 amps 1.0 amps
Certain insects can achieve seemingly impossible accelerations while jumping. the click beetle accelerates at an astonishing 400g over a distance of 0.52 cm as it rapidly bends its thorax, making the "click" that gives it its name. part a assuming the beetle jumps straight up, at what speed does it leave the ground? part b how much time is required for the beetle to reach this speed? part c ignoring air resistance, how high would it go?
What is the wavelength of the photons emitted by hydrogen atoms when they undergo n =5 to n =3 transitions?

On a map each inch represents 25 miles what is the length of a highway if it is 6 inches long on a map

Answers

Answer:

150 hope this helps

Explanation:

Answer:

150

Explanation:

A wire is wrapped around a piece of iron, and then electricity is run through the wire. What happens to the iron?

Answers

Search ResultsBy simply wrapping wire that has an electrical current running through it around a nail, you can make an electromagnet. When the electric current moves through a wire, it makes a magnetic field. ... You can make a temporary magnet by stroking apiece of iron or steel (such as a needle) along with a permanent magnet.

Hope This Helps!

20.0 moles, 1840 g, of a nonvolatile solute, C 3H 8O 3 is added to a flask with an unknown amount of water and stirred. The solution is allowed to reach 90.0°C . The vapor pressure of pure water at this temperature is 528.8 mm Hg. The vapor pressure of the solution is 423.0 mm Hg. How many kg of water was present?

Answers

Answer:

0.144 kg of water

Explanation:

From Raoult's law,

Mole fraction of solvent = vapor pressure of solution ÷ vapor pressure of solvent = 423 mmHg ÷ 528.8 mmHg = 0.8

Let the moles of solvent (water) be y

Moles of solute (C3H8O3) = 2 mole

Total moles of solution = moles of solvent + moles of solute = (y + 2) mol

Mole fraction of solvent = moles of solvent/total moles of solution

0.8 = y/(y + 2)

y = 0.8(y + 2)

y = 0.8y + 1.6

y - 0.8y = 1.6

0.2y = 1.6

y = 1.6/0.2 = 8

Moles of solvent (water) = 8 mol

Mass of water = moles of water × MW = 8 mol × 18 g/mol = 144 g = 144/1000 = 0.144 kg

Using an argument based on the general form of the Schrödinger equation, explain why if \psi (x) is a solution to the Schrödinger equation, then A\psi(x) must also be a solution if A is a constant.​I saw an explanation for this from another posted question, but this person put the explanation in numerical/equation form. Is there any way someone can explain the answer to this question in words (NON numerical/equation form)?

Answers

From a mathematical point of view, the Schrödinger Equation is a LINEAR partial differential equation, as is a partial differential equation that  is defined by a linear polynomial in the solution and its derivatives.

For a linear differential equation, if you got two different solutions\psi and \phi, then the linear combination \alpha \psi + \beta \phi, where \alpha and \beta are scalars, is also a solution.

This also is valid for only one solution (think of the other solution as equal to zero, \phi = 0 ). So, as the Schrödinger Equation is a Linear partial differential equation, then if \psi is a solution, then A \psi must also be a solution.

This is extremely important for physicist, as let us know that the superposition principle is valid.

The graph below shows the velocity of a car as it attempts to set a speedrecord.
Velocity vs. Time
1400
1300
1200
1100
1000
4 45
3
1 (s)
At what point is the car the fastest?
A. t = 1.0 s
B. t = 4.2 s
C. t = 3.0 s
D. t = 4.5 s

Answers

From the graph, it is clear that, the velocity is at a time of 1 s is highest. The velocity at 1 second corresponds to 1250 km/hr. Then it decreases with time.

What is velocity - time graph ?

The velocity - time graph shows the change in velocity with respect to time. The velocity is placed in y -axis and time is given in x - axis. The slope of the curve in velocity - time graph gives the acceleration of the object.

Similarly, the position of the object in meter after a t seconds can be determined from the velocity - time graph. It is the rate of change in velocity of the object.

From the graph, it is clear that, the curve has its peak at 1 second. After that the peak descends down. Hence, the maximum velocity of the car is at a time of 1 second at which the velocity is 1250 km/hr.

Find more on velocity - time graph :

brainly.com/question/28357012

#SPJ7

Guessing (A) because it had the highest velocity number on the graph and it matched 1s

Suppose that a ball is dropped from the upper observation deck of the CN Tower in Toronto, 450 m above the ground. Find the velocity of the ball after 2 seconds.

Answers

Answer:.

Required velocity = 6.26ms^-1

Explanation:

Given,

Distance, s = 450m

Time, t = 2 sec

Step 1. We obtain the distance covered within the given time under gravitational acceleration, g = 9.8ms^-2

S = ut + (1/2)gt^2. :; u = 0

: S = (1/2)gt^2

=(1/2) (9.8)(2^2)

= 19.6m

Step 2 :

We obtain the velocity using the formula.

V^2 = u^2 + 2gs.

Where u is initial velocity, v is final/ required velocity

Again u = 0

: V^2 = 2 (9.8)(19.6)

= 39.2

: V = 6.26ms^-1