A potential energy diagram is shown.
What is the activation energy of this reaction?
A potential energy diagram is shown. What is the activation - 1

Answers

Answer 1
Answer:

Answer:

Ea = 35 kJ.

Explanation:

Activation energy (Ea) is the difference between the potential energy of intermediate "activated complex/ peak" and reactants.

Ea = P.E. of products - P.E. of reactants = 65 kJ - 30 kJ = 35 kJ.

kindly find the attached image.


Related Questions

What units does a triple beam balance measure?!
Beverly and Carl are in a race. Their graphs show the data Which best describes the race?A. Even though for a majority of the race they accelerated at the same rate, Carl won because his initial acceleration was greater than Beverly’sB. Even though for a majority of the race they accelerated at the same rate, Beverly won because her initial acceleration was greater than Carl’s.C.Beverly accelerated at a greater rate for the entire race.D. Carl accelerated at a greater rate for the entire race
Please show information to support your answerWhich of the following is a sign of a chemical reaction?A. A liquid changes to a solid.B. A solid changes to a gas.C. A gas is released from a liquid.D. A liquid changes to a gas.
What does matter mean?
Which renewable energy sources should be developed in your area, and why? Consider abundance of the energy source, ease of setup in your area, and cost.Review the seven questions. Write a few sentences summarizing what you already know about these topics.

How is carbon dioxide obtained?

Answers

Carbon dioxide is obtained by fractional distillation of air . 
it is obtained especialy through breathing

what will most likely be observed when sulfur powder and iron powder are mixed together and then add water

Answers

Answer:

When Iron powder and Sulfur powder are mixed, no chemical reaction will occur, so you will see a physical change. The heterogeneous mixture resulting from mixing Iron powder with Sulfur powder could be easily separated using a magnet. When heating both compounds; however, it is possible to observe a chemical change as Iron Sulfide is formed. This product looks dark, shiny and is solid.

Sulfur will float and iron will sink because each will retain its properties

2 bromocyclopentanamine line formula

Answers

Answer:

The structure for 2 brormocyclopentan amine is given in attached file.

Explanation:

2-bromocyclopentamine (Figure attached) is a synthetic compound which is synthesized by substitution reaction of cyclopentamine and hydrobromide. Its molecular formula and molecular mass are C5H10NBr and 164.05 g/mol respectively.  It is a very reactive compound so it doesn’t available in pure form, it is present in market as a mixture of 2-bromocyclopentamine and Hydrobromide.

Properties:

Its boiling point is 115 °C.

Its melting point is  -75 °C.

It is highly flammable.

It is highly toxic.

It is irritant.

It is corrosive in nature.

If an orange is orange, why isn't a lime called a green or a lemon called a yellow?

Answers

A lime is called a lime because it's lime in colour and a lemon is called lemon because it's lemon in colour. Just to change the subject slightly why is a fly called a fly? - because it flies - so if a fly didn't have wings would it be called a walk. We could go on and on with this couldn't we and have a lot of fun too :)

Given the balanced equation representing reaction:N2 + energy ==> N + N
Which statement describes this reaction?
( I) Bonds are broken, and the reaction is endothermic.
(2) Bonds are broken , and the reaction is exothermic.
(3) Bonds are formed, and the reaction is endothermic.
(4) Bonds are formed, and the reaction is exothermic.

Answers

Answer: Option (1) is the correct answer.

Explanation:

In a N_(2) molecule, the nitrogen atoms are bonded together by triple bond.

Therefore, in order to break this triple bond high heat or energy has to be provided.

Thus, the reaction N_(2) + energy \rightarrow N + N shows that N triple bond N is broken down as energy is absorbed by N_(2) molecule.

Hence, we can conclude that in the given reaction bonds are broken, and the reaction is endothermic.

( I) Bonds are broken, and the reaction is endothermic.
(2) Bonds are broken , and the reaction is exothermic.
(3) Bonds are formed, and the reaction is endothermic.
(4) Bonds are formed, and the reaction is exothermic.

Which of the following statements does not describe a physical property of a piece of chalkA. Chalk is solid
B.chalk can be broken into pieces 
C. Chalk is white
D. Chalk will bubble in vinegar

Answers

D.) Chalk will bubble in vinegar.
This is a chemical property, not a physical property.